For your project slide a cross clamp up the suspension wire to the bottom of each gutter segment.
Diy gutter planter.
10 ft vinyl gutter but i only used about 6 feet of it 3 sets vinyl gutter end caps 1 4 inch natural fiber rope it comes in 50 feet rolls which is plenty home depot pdf instructions.
Garden answer youtube.
Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the.
The front and back of each gutter piece will have 2 holes.
Then thread the brace piece through the same clamp and tighten it with a screwdriver.
Start by drilling the bottom holes using your drill and 3 8inch bit.
This will lock each segment along the suspension wire.
Garden answer youtube.
Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter.