Mark the ledger length.
Deck ledger over siding.
Learn how to cut and remove aluminum vinyl wood and cement board siding for installing a deck ledger board to a house wall.
The ledger was all rotten as it was sitting tight to the siding so i assume water was accumulating behind it and was stuck there.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
Remove siding determine the outside dimensions of the framing for the deck and add to 1 to that length.
For the new one a friend of mine that does a lot of diy projects like that said i should just do the same and bolt the new one through the siding as it s still in perfect shape.
Deck ledger board deck ledger spacers.
Determine the floor joists location so that you will know exactly where to cut and remove the siding.
Deck ledger board.
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape measure pencil and chalk line.
Make sure you have enough room to install flashing above the ledger board and allow for at least a space above the decking preventing water from wicking upwards into wood siding.
Make a mark where the top of the deck should be the mark should be 1 3 inches below that.
After the ledger is installed a second strip of membrane tape is applied over the top of the ledger and about 1 2 in.
Set a water level on mark done for the ledger board then make another at a point longer than.
The attach a deck is a simple deck ledger mounting system that stands the ledger off the wall eliminating the need for flashing that s the big benefit but there are other features i like.
Start by using plunge cuts across the top and bottom of the horizontal length of the ledger board followed by the shorter vertical cuts for the ends using a cold chisel.
This will give you a to of extra room to maneuver the ledger if needed.
Start by making an outline on the siding where you want to position the ledger board.
Make the outline large enough to allow space for the.
Over time the house frame behind the deck will rot if it gets wet.
Attach a deck can be used to mount ledgers on new homes and retrofit decks over siding on existing homes the system is tested by an engineering service the installation is simple and fast lag screws can be used something the 2009 prescriptive ledger mounting table only permits for bolted ledgers.
The wall leg is at least 7 in.
Snap a chalk line cut out the siding and tack up the ledger board.